AS1FU202
This is an overhaul kit for the Fispa Fuel Pressure Regulator.
![AS1FU202 Rebuild kit for Fispa Fuel Pressure Regulator WITH Pin AS1FU202 Rebuild kit for Fispa Fuel Pressure Regulator WITH Pin](../media/trans.gif)
Please note that Fispa has produced at least two different versions over the years:
- The version WITHOUT a pin on the center of the diaphragm
- This version here WITH a pin on the center of the diaphragm
The difference between the two will be clear from this picture:
![AS1FU202 Rebuild kit for Fispa Fuel Pressure Regulator WITH Pin AS1FU202 Rebuild kit for Fispa Fuel Pressure Regulator WITH Pin](../media/trans.gif)
There are more differences than just the pin but the pin is the best indicator for which kit you need.
![AS1FU202 Rebuild kit for Fispa Fuel Pressure Regulator WITH Pin AS1FU202 Rebuild kit for Fispa Fuel Pressure Regulator WITH Pin](../media/trans.gif)
The set with the diaphragm WITHOUT pin can be found HERE.
Officially, this set suits both the Fispa FB43 and FRB11 fuel filters with build-in pressure regulator.
The bolt pattern is as follows: circa 33 mm heart-to-heart and about 42 mm across (diagonally).
The diameter of the pin is circa 2.45 mm while it stands some 8 mm tall, measured from the face of the larger dish at the top.
This product is priced, and sold, as a kit - as depicted.
This set is E10- and bio-fuel resistant.
* Made in the UK *