G40 Stainless Steel Push-fit Mesh Trumpet Gauze for 40 mm Trumpet

Stainless Steel Push-fit Mesh Trumpet Gauze for a 40 mm diameter trumpet.

These trumpet gauzes / covers are ideal for installations with very little clearance and room.

With the outer ring being made of rubber, they can be easily removed and re-fitted for shows etc.

These have a soft outer ring that is a push fit over 57 to 58 mm diameter trumpets.

The gauze is made up of 2 layers of stainless steel wire with a fine mesh filter sandwiched between them.

They will fit:

• Dellorto DHLA 40 & DRLA 40 trumpet
• Weber DCO; 40 trumpet
• Solex & throttle body trumpet with 57 – 58 mm fitting over flared ends
• Will suit Weber 40DCOE, Solex ADDHE 40 mand Dellorto DHLA / DRLA 40 with our trumpet # 8257
• Other trumpets that have a 57 to 58 mm our diameter flare

The gauze dome is approximately 28 mm high.

The version for 45 mm carburetors can be found HERE.

This product is priced and sold as a set of 2 and the carburetor shown in the picture is NOT included.

G40 Stainless Steel Push-fit Mesh Trumpet Gauze for 40 mm Trumpet

G40 Stainless Steel Push-fit Mesh Trumpet Gauze for 40 mm Trumpet

G40 Stainless Steel Push-fit Mesh Trumpet Gauze for 40 mm Trumpet

G40 Stainless Steel Push-fit Mesh Trumpet Gauze for 40 mm Trumpet